Nice MORX Installation Instructions Manual page 39

Table "F11" Delete memory directly from the READER
This function cancels all the data contained in the memory.
1. Pass any MASTER in front of the READER five times
2. Wait for 3 tones
3. Immediately after the third tone hold the MASTER in front of the READER
4. Wait for 5 tones
5. Immediately after the fifth tone, remove the MASTER
N.B.: If the memory is deleted the MASTERS will be deleted, too.
Table "F12" Programming an output in the BISTABLE mode
This procedure associates the BISTABLE function with an output so that the output can be
alternatively activated or deactivated.
Set the "timer" function to less than 0.5 seconds to return to the "momentary" mode.
1. Pass the MASTER in front of the reader six times (see note)
2. Then hold the MASTER in front of the READER
3. Wait for 1 tone
4. Immediately after the tone, remove the MASTER
N.B.: At point 1 MASTER 1, MASTER 2 or the SOLE MASTER must be used depending on which output the BISTABLE mode is to be
associated with (the SOLE MASTER associates the mode with both outputs).
38
Example
x5
Example
x6