Table of Contents
Advertisement
UBS Hydro II
Maintenance
7.3.4
Maintenance after 100 operating hours / longer down-time
DANGER
2018-05-02
Danger to life or risk of injury due to a running machine!
A running machine can cause danger to life or risk of injury, as well as risk of
material damages to the machine or system!
•
Prior to maintenance works, disconnected the machine from the power
supply and secure it against unintended switching on.
The user shall plan, perform and record the tests considering the applicable
regulations and laws.
The safety devices must be ensured, in order to ensure a safe operation of the
machine:
At an interval of maximum 100 operating hours, as well as at the beginning and the
end of the season, all movable parts must be greased or oiled.
Lubrication points
Personnel:
•
Private and commercial users
Protective equipment:
•
Protective clothing
•
Protective gloves
•
Safety goggles
•
Take off the fan housing after each 100 operating hours or at least once a
year - preferably before the season starts - and clean the cooling fins on the
cylinder and the cylinder head, as well as the baffle plates, cooling air sieves
and oil coolers required for the circulation of air.
•
Replace hydraulic oil and filter for the first time after 20 operating hours, then
every 100 operating hours. Replace hydraulic oil filter within the same time
intervals as the oil changes take place. (For the types of oil used refer
to(See chapter 10 Technical data on page 53))
•
Clean the spark plug from soot deposits using a wire brush and finally check
the distances of the electrodes. The electrode distance shall be approx. 1
mm. Replace after approx. 200 operating hours.
•
Air filter - Clean the cartridge after 100 operating hours and if there are very
dusty conditions, after a few hours.
42 / 60
EN
Advertisement
Table of Contents
