Table of Contents
Advertisement
UBS Hydro II
Safety
WARNING
2018-05-02
•
Beware of coasting down tools. Before working on these components, wait
until they stopped completely!
•
If the attachment is blocked by a foreign body, switch the engine off and
clean the attachment using a suitable tool!
•
There are crushing and shearing positions on driven parts!
•
It is forbidden to transport people and objects!
•
Driving behaviour, steering and possibly braking capability as well as
tipping behaviour are influenced by attached or hooked-up devices and
load. For this reason, only the attachments are allowed to be used that
have been approved by the manufacturer. Adapt the working speed to the
current conditions.
•
Do not change the maximum idle speed of the engine. A too high speed
will increase the risk of injury.
•
Unauthorised modifications that put operational safety of the machine at
risk are forbidden!
•
If the self-propelled working machine or the attachment is damaged,
immediately switch the engine off and get the damage repaired!
•
If there is a risk of sliding off in sloping areas, it is required that an
accompanying person secures the host vehicle using a bar or a rope. The
accompanying person has to be above the vehicle at a sufficient distance
from the working tools! The assistant should wear pole climbers.
•
Drive across the slope, if possible.
•
Under humid and rainy conditions, do not use the machine at the slope.
•
On steep slopes, use grid wheels or spike wheels to avoid sliding off.
•
In case steering is troubled, immediately stop the self-propelled working
machine and switch the engine off. Immediately eliminate the malfunction.
•
Before each commissioning, check the machine for operational safety!
•
If the working machine starts sliding down at the slope, immediately let off
the handles.
Coupling and decoupling of attachments
Risk of injury / risk damage to environment due to nonobservance of safety
measures!
There is a risk of injury, as well as a risk of damage to environment and material
damages (on the machine or the system) due to nonobservance of safety
measures!
•
Observe the relevant instructions and safety instructions of the host
vehicle.
•
When changing the attachments and their components use suitable tools
and wear gloves.
•
For mounting and demounting place the necessary supports in the
respective position and provide for sufficient stability.
•
Secure the self-propelled working machine and the attachment against
rolling away (locking brake, chocks).
13 / 60
EN
Advertisement
Table of Contents
