Mounting Instructions - CDVI DGLIWLC Installation Manual

INSTALLATION MANUAL
DGLIWLC - DGLIFWLC
Proximity Card Readers - Wiegand Output

6] MOUNTING INSTRUCTIONS

Make sure that there are no pieces missing in the mounting kit. Get the right tools according to the
installation type (Drill, screw drivers, metre tape,...) and follow the mounting instructions of the reader.
Ref : DGLIWLC
1
Measure and mark the
center lines to determine
the reader position. Drill
the fixing screw holes
(Diametre: 4MM for the
mounting plate and 6MM
for the reader). Drill the
wiring access area.
2
Insert the brass anchors
in the mounting holes,
connect the cable to
the terminal block,
then fasten the reader
with the DIAX screws
®
using the DIAX span-
®
ner. Make sure that the
varistor is connected on
the lock (refer to page 2
«Recommendations»).
Ref : DGLIFWLC
1
Measure and mark
the center lines to
determine the reader
position. Drill the fixing
screw holes (Diametre:
4MM for the mounting
plate and 6MM for the
reader). Drill the wiring
access area.
EN
2
Insert the brass an-
chors in the mounting
holes, connect the
cable to the connectors,
then fasten the reader
with the DIAX screws
®
using the DIAX span-
®
ner. Make sure that the
varistor is connected on
the lock (refer to page 2
«Recommendations»).
cdvi.com
11
cdvigroup.com