Page 1
Spreading chart ZA-M Centrifugal broadcaster Before starting to operate MH646 A.003 / 12.15 carefully read the instruction Printed in Germany bookand adhere to the safety advice!
Page 2
If the fertiliser can not clearly be assigned to a certain fertiliser type in the setting chart, go to www.amazone.net – Fertiliser Database or, on the App for both Android or iOS smartphones, to find the up to date amendments to the setting chart...
Page 8
General Instructions for avoiding spreading errors Store the fertiliser properly (refer to manufacturer's instructions) Adjust the machine in accordance with the setting charts, the Internet database and observing the recommended instructions in the operator manual. Check the spread rate before starting spreading. Check the adjusted working width (distance between the tramlines) using the mobile test kit (optional equipment) when using unknown types of fertiliser and also for general checking purposes.
Page 9
Twin disc spreaders Spreading discs With a twin disc spreader from AMAZONE it is possible to spread various working widths with only one set of spreading discs. Refer to the setting chart, the Internet database or the recommended adjustments for information about which spreading disc is required for which working width.
Page 10
Turning the spreading vanes in the direction of rotation (Fig. 1/A) of the spreading discs (to a higher numerical scale value) will increase the working width. Turning them in the opposite direction (Fig. 1/B) will reduce the working width. The shorter spreading vane distributes the fertiliser primarily in the centre of the spread pattern, whereas the longer vane covers the outer area.
Page 11
avoided. Do not reduce the slide position in these cases. You will find the settings for the respective fertilisers in this setting chart. Fig. 3 Boundary spreading Avoids any fertiliser spreading beyond the boundary, e.g. in case of areas not to be treated identically. An underfertilised edge strip of 2 to 6 m is automatically produced dependent on the distance of the first tramline to the boundary (see Fig.
Page 12
When carrying out side, boundary or water course spreading 6.4.1 With hydraulic spreading disc drive The adjustment of the spreading disc on the field edge side depends on the working width, the kind of fertiliser, the spreading mode (side, boundary or water course spreading) and the spreading disc. Effect of speed changes: Speed increase: spreading range larger, spread pattern flatter Speed reduction: spreading range smaller, spread pattern steeper...
PK 12+24 + S ICL Fertilizers - Europe C. V. (80000550) Diameter: 3,08mm Bulk density: 1,1kg/l Flow factor: 0,92 Disc OM 10-12 OM 10-16 OM 18-24 OM 24-36 Working width[m] Vane setting 18/47 18/47 15/46 15/46 15/47 15/47 12/40 13/41 13/41 15/42 8/36...
Need help?
Do you have a question about the ZA-M 3001 and is the answer not in the manual?
Questions and answers