Panasonic KV-SS080 Service Manual page 28

8.2.15. Drive Belt
1. Remove the Scanning Unit. (See 8.2.14.)
2. Remove the Drive Belt from the slot of the Scanning Unit.
Note: Adjusting the belt tension
1. Perform the steps in the reverse order in Sec. 8.2.13,
8.2.14, and 8.2.15 to reassemble the Drive Belt,
Scanning Unit, and Shaft.
2. Reattach the Motor Assy. in the reverse order in
Sec.8.2.11, and then reattach the Drive Belt to the
pulley on the Tension Plate Assembly.
3. Loosen the 2 screws (c) and screw (d) again so that the
belt tension increases on its own.
4. Tighten the 2 screws (c) and screw (d).
28