Ld0.Ledggio1 Indication Led States Color1/Color2 - ABB RELION 611 Series Modbus Point List Manual

1MRS758336 B
BitA RegA
3054 190.14
3055 190.15
2.3.1.8
Table 11:

LD0.LEDGGIO1 Indication LED states Color1/Color2

BitA RegA
3520 220.00
3521 220.01
3522 220.02
Table continues on next page
REU611
Point List Manual
IEC 61850 name SA name
LD0.FRPFRC2
.Op.general OPR_FRG
.mcd
LD0.LEDGGIO1 Indication LED states Color1/Color2
These LED indication points interpret the case when a signal is wired to both the OK
and ALARM inputs, but inverted to the other. This means that the LED toggles
between red and green colors. The default color for ALARM is red and green for OK.
Colors can, however, be reconfigured with a setting parameter.
Signal
NOT
GUID-2AE4D47A-2BBD-4422-A81C-CF2EB7473379 V1 EN
Figure 2: Signal wired to both OK and ALARM inputs – inverted to the other
If the OK and ALARM inputs are wired to separate indication signals,
the LED will have three legal states and cannot be expressed with one
bit only. In this case, it is possible to combine this LED bit
interpretation with the corresponding value from the other LED state
interpretation.
Signal 1
OK
Signal 2
ALARM
RESET
GUID-051741E8-4D66-412C-BA0A-0B849B5E58F2 V1 EN
Figure 3: Separate signals wired to OK and ALARM inputs
IEC 61850 name SA name
LD0.LEDGGIO1
.LEDSt1.stVal -
.LEDSt2.stVal -
.LEDSt3.stVal -
Modbus data mappings
Description
Frequency gradient
Operate
LEDx
OK
ALARM
RESET
LEDx
Description
LED 1 state
LED 2 state
LED 3 state
Section 2
Values
1=Operate
Values
0/1=Color1/2
0/1=Color1/2
0/1=Color1/2
15