Safety Notes; Installation Instructions; Symbol Description - Hans Grohe Decor 280 1jet 31817 3 Series Instructions For Use And Assembly Instructions

Safety Notes

Gloves should be worn during installation to prevent
crushing and cutting injuries.
The hot and cold supplies must be of equal
pressures.

Installation Instructions

• Prior to installation, inspect the product for transport
damages. After it has been installed, no transport or
surface damage will be honoured.
• The pipes and the fixture must be installed, flushed
and tested as per the applicable standards.
• The plumbing codes applicable in the respective
countries must be observed.
Technical Data
Operating pressure:
Recommended operating pressure:
Test pressure:
Hot water temperature:
Recommended hot water temp.:
Thermal disinfection:
The product is exclusively designed for drinking water!

Symbol description

Do not use silicone containing acetic acid!
Fault
Insufficient water
Mixer stiff
Mixer dripping
Hot water temperature too low
Water escaping in area of swivel
spout
Water escaping at the threaded
base
2
max. 1 MPa
0,1 - 0,5 MPa
1,6 MPa
(1 MPa = 10 bar = 147 PSI)
max. 70°C
max. 70°C / 4 min
Cause
- Aerator calcified, dirty
- Cartridge defective, calcified
- Cartridge defective
- Hot water limiter incorrectly set
- O-ring defective
- connection hoses not completely
screwed into basic body
- Dirt or sedimentation on valve seat. - Exchange O-ring
Assembly (see page 4)
English
Adjustment (see page 8)
To adjust the hot water limiter. Using a hot water limiter
in combination with a continuous flow water heater is
not recommended.
Dimensions (see page10 )
Flow diagram (see page 10)
Spare parts (see page 12)
XX = Colors
00 = Chrome Plated
14 = Brushed Bronze
31 = Brushed Redgold
34 = Brushed Black Chrome
67 = Matt Black
95 = Brushed Brass
Cleaning (see page 14)
Operation (see page 9)
Hansgrohe recommends not to use as drinking water
65°C the first half liter of water drawn in the morning or after
a prolonged period of non-use.
Remedy
- Clean aerator, replace as
necessary
- Exchange cartridge
- Exchange cartridge
- Set hot water limiter
- Exchange O-ring
- Tighten connection hoses by hand