4. Hardware Features
Technical Specifications
Network connection
-
10Base-T or 100Base-TX Ethernet connection
-
Standard 8P8C ("RJ45") socket connector
-
TCP/IP protocol stack
-
DHCP or static IP address
-
Automatic transmit/receive crossover detection
-
1500V magnetic isolation
RS-232 Serial Port
-
Baud rates up to 1M Baud
-
5, 6, 7 or 8 data bits
-
1, 1.5 or 2 stop bits
-
Odd, even, mark, space or no parity bit
-
Line-break generation and detection
-
RTS/CTS or XON/XOFF flow control option
-
ESD protection to 15kV human body model
-
Can be connected to as a Windows COM port, as a
Raw TCP socket, or using the RFC2217 standard
-
Serial cable length: 10m / 30 feet maximum
RS-422/485 Full Duplex Serial Port
The factory default setting for the ES devices is RS-422 full duplex.
Background Information:
DTR/DSR and CTS/RTS Handshaking is not available.
This mode is generally used between one transmitter / receiver to only one other transmitter /
receiver, but it is possible for each output to drive up to 10 receivers.
Generally, in RS-422 systems, all 4 signal lines from the 5 pin terminal block participate in the data
transfer sequence. Thus 2 twisted pair cables are used. One twisted pair carries the TXD data
outwards, one pair brings the RXD data inward.
-
Baud rates up to 1M Baud
-
5, 6, 7 or 8 data bits
-
1, 1.5 or 2 stop bits
-
Odd, even, mark, space or no parity bit
-
Line-break generation and detection
-
XON/XOFF flow control option
-
Built-in termination and biasing at receiver inputs
-
Can be connected to as a Windows COM port, as a Raw TCP socket, or using the RFC2217
standard
-
Serial cable length: 1200 meters / 4000 feet maximum
ES Industrial Range
Product Manual V3.3
© Copyright Brainboxes Ltd
Page 9 of 53