Turn On Progressive Scan; Use Philips Easylink - Philips HTS6120/37 User Manual

Turn on Progressive Scan

If the TV supports progressive scan output, you
can connect this Home Theater System and
the TV using component video connection.
(see 'Connect video cables' > 'Connect to the
component video jack').
TV System
TV Display
Picture Setting
HDMI Setup
Closed Caption
Progressive
1
Turn on the TV and ensure that the TV
progressive scan mode is deactivated (see
the TV user manual).
2
Switch the TV to the correct viewing
channel for this Home Theater System.
3
Press DISC .
4
Press SETUP .
5
Press to select [Video Setup] in the
menu, then press .
6
Select [Progressive] > [On] , then press
OK .
»
A warning message is displayed.
7
To proceed, select [Ok] and press OK .
»
The progressive setup is complete.
Note
•
If a blank/distorted screen is displayed, wait for
15 seconds for the auto recover.
•
If no picture displayed, turn off the progressive
scan mode as follows: 1) Press to open
the disc compartment. 2) Press . 3) Press
AUDIO SYNC .
8
Press SETUP to exit the menu.
9
You can now turn on the progressive scan
mode on the TV.
24 EN
On
Off
Note
•
During play, when progressive scan mode is on
for both this Home Theater System and the
TV, distorted picture may display. Turn off the
progressive scan feature on both this Home
Theater System and the TV.

Use Philips EasyLink

Your Home Theater System supports
Philips EasyLink, which uses the HDMI CEC
(Consumer Electronics Control) protocol.
EasyLink-compliant devices that are connected
through HDMI connectors can be controlled by
a single remote control.
Note
•
Philips does not guarantee 100%
interoperability with all HDMI CEC devices.
1
Turn on the HDMI CEC operations on
the TV and other connected devices. See
TVs/devices manual for details.
2
You can now enjoy the following Philips
EasyLink controls.
EasyLink
You can turn off or turn on all EasyLink
features.
One-touch play
When you connect your Home Theater
System to devices that support one-touch
play, you can control your Home Theater
System and the devices with one remote
control. For example, when you press Play
on your DVD remote control, your TV
automatically switches to the correct channel
to show the DVD content.
To enable One-touch play, a video disc must
be placed in the disc compartment before
operation.