Table of Contents
Advertisement
English
Safety instructions
Mechanical hazards
Cut wires can have sharp ends and can cause serious injuries. Watch
out for sharp edges when you pick up the PCB.
Visibly damaged parts can cause unpredictable danger. Do not use
damaged parts: recycle and replace them with new ones.
Electrical hazards
§
Touching powered, live components,
§
touching conducting components which are live due to malfunction,
§
short circuits,
§
connecting the circuit to a higher voltage than designed,
§
impermissibly high humidity,
§
condensation of water
can cause serious injury due to electrical shock. Take the following
precautions to prevent this danger:
§
Never perform wiring on a powered module.
§
Only use low power for this module as described in this manual and
only use certified transformers.
§
Connect transformers and soldering stations only in approved mains
sockets installed by an authorised electrician.
§
Observe cable diameter requirements.
§
After the condensation of water do not start working until after a
minimum of 2 hours of acclimatisation.
§
Mounting the module should only be done in closed, clean, dry
rooms. Beware of humidity.
§
Use only original spare parts if you have to repair the module.
Fire risk
Touching flammable material with a hot soldering iron can cause life-
threatening fire, burns and toxic smoke. Connect your soldering iron or
Page 20
KSM-1
Advertisement
Table of Contents
