Installing Harness System - Cosco Scenera Manual

Cleaning Pad
Hand wash pad with warm sudsy water, rinse clean and air
dry. Do not use bleach or use other harsh cleaners. Do not
dry clean or machine wash.
Harness Straps: Spot clean only. Do not machine or hand
wash.
NOTE: Do not wash the pad while still on the shell. Spot
clean only if it is not removed.
Do not use this child restraint or booster seat
without the seat pad. Failure to do this can
result in serious injury.
Install Pad
Replace seat pad by reversing order for your particular model.
Starting from bottom of child restraint, slip pad on shell.
Pull harness adjustment strap through pad.
Attach all of the elastic straps.
Install lower harness guides.
Install harness system (see section C-8).
C-8 Installing Harness System
1. Install Buckle Strap
From the front of child
restraint, push buckle strap's
metal retainer through pad
1
and shell.
2
Make sure that buckle is
3
facing out.
You MUST use the 1st or 2nd buckle strap slots
when rear facing. Any slot can be used for
forward facing.
25
4358-5974A CAN Scenera ENG.indd 27-28 4358-5974A CAN Scenera ENG.indd 27-28
2.
From bottom of child restraint,
pull metal retainer completely
through pad and shell.
3.
Check Buckle
Pull up on buckle strap to
make sure it is secured.
The buckle must not pull
out.
Failure to place buckle strap's metal
retainer completely through pad and shell
can result in serious injury or death to the
child.
4.
Thread Harness Strap
(1) If you have fully removed
1
the harness straps,
sewn end of the harness
strap loop facing the buckle,
thread the harness strap down
through lower harness guide
on left side of shell.
2
(2) Pull across bottom of shell
and up through lower harness guide on right side of shell.
5. Take both ends of the
harness strap and make them
even in length.
The sewn ends of the harness
strap loops
other as shown.
DO NOT twist harness
straps.
26
with
MUST face each
continued on next page
10/23/14 8:57 AM 10/23/14 8:57 AM