Securing Child In Child Restraint - Cosco Scenera Manual

b. Rethread harness straps into
new upper harness slot location.
NOTE:
harness straps.
11.
Attach Harness Straps to
Splitter Plate
From the back of the child
restraint, fit the harness strap
loops onto the splitter plate.
NOTE: Make sure sewn end of the harness strap loops
face towards you. DO NOT twist harness straps or
harness adjustment strap and make sure the harness
straps are COMPLETELY ON the splitter plate.
Do not use this child restraint rear
facing if the top of your child's head is
above the top of the child restraint's
headrest.
Do not use this child restraint forward
facing if the midpoint of your child's
head is above the top of the child
restraint's headrest.
Make sure the harness height is correct for your
child's size.
Incorrect use of the harness system is the most
common mistake people make. Verify frequently
that the harness height is correct for your child's
size. It is very important to read, understand and
follow all instructions and warnings.
Failure to follow these steps can result in
serious injury or death.
17
4358-5974A CAN Scenera ENG.indd 19-20 4358-5974A CAN Scenera ENG.indd 19-20
DO NOT twist the
C-3 Securing Child in Child Restraint
1. Position Harness
Straps Over the
Child's Shoulders
Place the child's bottom
and back flat against the
child restraint.
This will allow the harness
straps to be properly
tightened.
2.
Buckle Harness Straps
Push each buckle tongue
into buckle until you hear a
"click."
Remember to always pull
up on harness straps to
make sure buckle is locked.
3.
Close Chest Clip
Insert right half of chest clip
into left half and snap together.
18 continued on next page.
10/23/14 8:57 AM 10/23/14 8:57 AM