Pentair INTELLIFLO VSF Series Quick Start Manual page 8

Controls and Leds on keypad
Button 1: Press to select Progam 1 (750 RPM). LED on
1
indicates Program 1 is active.
2
Button 2: Press to select Program 2 (1500 RPM). LED on
indicates Program 2 is active.
3
Button 3: Press to select Program 3 (2350 RPM). LED on
indicates Program 3 is active.
4
Button 4: Press to select Program 4 (3110 RPM). LED on
indicates Program 4 is active.
5
Back: Goes one step back in menu; exits without saving
current setting.
Save: Saves current menu item setting. When a parameter
6
has been adjusted the "Save?" icon will be displayed.
Menu: Accesses the menu items when and if the pump is
7
stopped.
Select: Press to select the currently displayed option on the
8
screen.
Arrow buttons:
9
• Up arrow: Move one level up in the menu or increase
a digit when editing a setting.
• Down arrow: Move one level down in the menu or
decrease a digit when editing a setting.
• Left arrow: Move cursor left one digit when editing
a setting.
• Right arrow: Move cursor right one digit when
editing a setting.
Quick Clean: Pump increases to a higher RPM (for
10
vacuuming, cleaning, adding chemicals, etc.). LED light is
on when active.
Time Out: Allow the pump to remain in a stopped state for a
11
set period of time before resuming normal operation. LED
is on when active.
Start/Stop button: To start or stop the pump. When LED is
12
on, the pump is running or in a mode to start automatically.
13
Reset button: Reset alarm or alert.
14
LEDs:
On: Green light when pump is powered on.
Warning: On if warning condition is present.
Alarm: Red LED on if alarm condition occurs.
Control Panel LCD Screen:
15
• Line 1: Key icon indicates password protection mode is
active. If password protect is not enabled, no key icon is
displayed. Also shows current time of day. Active cursors
display when arrow key input is available.
• Line 2: Displays current pump speed/flow (RPM or m³/h).
• Line 3: Countdown time and watts
• Line 4: Current pump status and current feature.
"Save?" will display on this line when a parameter
adjustment can be saved.
8
Note: Always close the keypad cover after using the keypad.
Note: Using screwdrivers or pens to program the pump will damage the keypad
overlay. Use your fingers only when programming the pump.
750 RPM
T 0.00 150 WATTS
Running Speed 1
1 2
1
2
5
Back
Select
Time
Quick
Out
Clean
Control Panel #1-8
Line 1
750 RPM
Line 2
15
T 0.00 150 WATTS
Line 3
Line 4 Running Speed 1
1 2
Back
Select
14
Quick Time
10
Out
Clean
11
Control Panel #9-15
Key Lockout Icon
12:15p
3 4
4
3
6
Save
7
Menu
8
Active Cursors
Current Time
12:15p
Current Speed
Countdown Time
Current Power Usage
"Save?" Icon
Save?
Current Running
Feature
3 4
Save
Menu
9
13
12
P-QSG-VSF - Rev.November 2017