Appendix E. Mpr Series Breakout Board - Honeywell SEK002 User Instructions

Sensor Evaluation Kit, SEK002

APPENDIX E. MPR Series Breakout Board

Figure E1. MPR Series Breakout Board Schematic and Dimensions
The MPR Series sensors are available on a breakout board, allowing power and
communications lines to be more easily attached to a sensor without the risk of hand
soldering or the expense of creating your own evaluation PCB. The breakout board can be
used with the SEK002 Sensor Evaluation Kit and software or any I
If the SEK002 is not used, please provide 1 kOhm pull up resistors on SCL and SDA lines
when using I C communications. Refer to the MPR Series data sheet for programming
2
instructions.
Breakout board
connector pin
10
9
8
7
6
5
4
3
2
1
APPENDIX F. Cable 32332297-00
Figure F1. Cable 32332297-001 Dimensions
The 32332297-001 is a specialized cable, available separately from Honeywell, used to connect the HPM Series to the SEK002.
Do not use cables from other manufacturers.
Pin
8
7
6
5
4
3
2
1
Schematic
NC
Pad
NC
MOSI/SDA
2
SCL/SCLK
3
MPR Series
MISO
7
V
SS 10
SS
1
V
DD
12
0.1 µF
Dimensions (For reference only: mm/[in].)
2 C or SPI control circuit.
Sensor
150
[5.9]
Issue A
32333651
Breakout board dimensions
(For reference only: mm/[in].)
18,00
[0.71]
ø
2x 3,50
[0.14]
Pin
1
2
3
4
5
6
7
8
Sensing and Internet of Things 15
44,00
[1.73]