Installation Of The Pci Driver; Fig. 4 Installation Of The Pci Driver; Fig. 5 Resources Of The Pci Driver - Beckhoff FC7501 Documentation

Installation
3.2

Installation of the PCI driver

After installation of the SERCOS card, Windows 2000, for example, comes up with the following message
during start-up:
Fig. 4: Installation of the PCI driver
The PCI driver for the SERCOS card is supplied with the Beckhoff TwinCAT automation software.
Follow the instructions of the Add Hardware Wizard.
Under Windows XP, the PCI driver is installed in the same way.
Under Windows NT 4.0, the PCI driver is not required.
Example for the resources of an FC750x under Windows2000
(Control Panel / System / Hardware / Device Manager / TwinCAT PNP drivers /
TwinCAT FC750x PCI driver / Resources):
Fig. 5: Resources of the PCI driver
IRQ is not used
The PCI bus allocates an IRQ to the SERCOS card (IRQ9 in the example). Although the
IRQ is not used by the SERCOS card!
Note
12 Version: 2.0 FC7501 and FC7502