Electrical Connection - Fagor Advance Plus APG-061 Installation Manual

INSTALLATION MANUAL ADVANCE PLUS
ENGLISH

ELECTRICAL CONNECTION

An AUTHORISED TECHNICIAN should always carry out the appliance's
electrical connection.
The legal standards in force in each country on connections to the mains should
be taken into account.
Check that the mains voltage corresponds to that indicated on the nameplate.
Power cables should be flexible cables with oil-resistant cover, and should not
be lighter than ordinary cable sheath ordinary polychloroprene or equivalent
synthetic elastomer (H05RN-F).
A switch device should be installed next to the appliance for all the phases, with
a gap of a minimum of 3 mm between contacts. This switch will be equipped
with fuses.
The appliance must be earthed, from the connection strip of the appliance to the
earth connection of the main power supply.
The manufacturer will not be held liable for damage originated by failure to
observe this requirement.
To access the connection strip, release the left side panel (Fig 8), pass the
cable hose through the stuffing box on the exterior base and connect as shown
on the strip.
Fig. 8
VERY IMPORTANT: Before installing the left side panel, attach the electrical
supply hose securely to the stuffing box.
When several appliances are installed in series, they should be earthed to each
other using the point assigned for this purpose, located in the fryers base, at the
back.
24