Weinmann & Schanz Heatapp! System Installation Instruction page 58

3.4.1.2 Connection test
In the last step, check the connection of the installed radio modules to
the heatapp! gateway.
1. In your PC's browser, select menu item "Connection test". You can
now see a list of the registered radio modules and their connection
status.
2. Click on the button "Test modules" and then "Test modules".
3. Then on one of the fitted heatapp! drive press and hold the key
(Fig. 8, C, item 1) until "M" is flashing in the display.
4. Now press the key (Fig. 8, C, item 2). "LI" is now shown in the
display.
5. Confirm the test by pressing key (Fig. 8, C, item 1).
6. Repeat steps 3. - 5. for all actuators.
A green dot is shown for each heatapp! drive with a successful
connection to the heatapp! gateway.
If you do not have a working connection to one or more heatapp! drive,
then the wireless range is insufficient!
Relocate the heatapp! gateway at another location so that all
•
radio modules can be reached. Repeat the connection test.
If this does not work, add a heatapp! repeater
•
wireless coverage. Follow the instructions for installation and
registering a heatapp! repeater in section 3.4.2 "heatapp!
repeater".
The heatapp! repeater is not included in the standard scope of delivery; it must be
1)
ordered as an accessory.
1)
to improve
EN - 25