Weinmann & Schanz Heatapp! System Installation Instruction page 57

3.4.1.1 Register the heatapp! drive actuators:
1. To register the heatapp! drive click on the menu item "Radio
modules".
2. Unpack a heatapp! drive and insert the AA batteries in the battery
compartment (Fig. 8, A). Ensure you connect the positive and
negative terminals correctly!
3. In your PC's browser, select the menu item "Include and exclude"
and then "Start inclusion process". You will be requested to press
the learn key on the heatapp! drive.
4. The display on the heatapp! drive displays a flashing "M". Now
press the learn key (Fig. 8, B, item 1) in the middle below the
display. If the heatapp! gateway recognises the heatapp! drive,
you are requested to enter a name for this actuator (e.g. "Window
radiator") and allocate the actuator to a room that was created in
the heatapp! base set-up.
5. Fit the heatapp! drive to the corresponding radiator valve in the
allocated room according to the enclosed installation instructions.
6. Repeat steps 3. - 5. for all radiators and rooms.
24 - EN