Weinmann & Schanz Heatapp! System Installation Instruction page 49

1. Switch the power supply for the heatapp! base on.
2. Connect the heatapp! USB-LAN adapter from the installation kit to
the heatapp! base and the PC / laptop:
A Plug the heatapp! USB-LAN adapter into a free USB port on
the top side of the heatapp! base.
B Start the PC / laptop. Connect the heatapp! USB-LAN adapter
to the network port of the PC / laptop.
Shortly thereafter, the set-up assistant starts automatically in the
browser window of your laptop. If the set-up assistant does not start
automatically, enter the address
browser.
3. Follow the instructions in the set-up assistant.
After set-up the heatapp! base is successfully connected to the
customer network and the Internet if the top LED "Network" on the
heatapp! base remains a steady GREEN.
Please refer to section 5.1 "LEDs heatapp! base" to determine the
meaning of other conditions and for troubleshooting instructions.
4. Remove the heatapp! USB-LAN adapter from the USB-Port of the
heatapp! base and now install the heatapp! gateway.
16 - EN
http://10.0.0.1 in the address line of the