Tennant 8010 Instruction Bulletin

INSTRUCTION BULLETIN
NOTE: DO NOT DISCARD the Parts List from the Instruction Bulletin. Place the Parts
List in the appropriate place in your machine manual for future reference.
Retaining the Parts List will make it easier to reorder individual parts and will
save you the cost of ordering an entire kit.
NOTE: Numbers in parenthesis ( ) are reference numbers for parts listed in Bill of Materials.

Installation instructions for kit number 363990

SYNOPSIS / PROBLEM:

This kit contains the parts needed to install a new hopper prop rod on the model 8010
sweeper/scrubber.
Please follow step-by-step instructions.
SPECIAL TOOLS / CONSIDERATIONS: welder, temporary hopper prop device
(Estimated time to complete: 2 hours)

PREPARATION:

(Refer to FIG. 1, 2 and 3)
FOR SAFETY: Before leaving or servicing machine, stop on level surface and set parking
brake. Then turn off machine and remove key.
1. Open hopper cover and engage existing prop rod.
2. Create a temporary prop arm from a wood 2x4 or stronger material aproximately 4'to
5'(60" ) long.

INSTALLATION:

(Refer to FIG. 1, 2 and 3)
3. Support hopper cover with temporary prop arm placed under the left side of hopper.
4. Remove and discard all parts of existing prop rod.
5. Using dimensions from FIG. 1, weld bracket (8) to the top right side of the hopper.
(Refer to FIG. 1, 2 and 3)
6. Mount cover support plate (5) with four hex screws (6) and washers (7).
(Refer to FIG. 2 and 3)
7. Once weld has cooled, mount cover rod (1) to bracket (8) using hex screw (2), washers (3)
and nylon hex nut (4).
8. Remove temporary prop arm and check stability of new hopper prop arm assembly.
9. Disengage prop arm and close hopper cover.
IB 340174 (6-98) LITHO IN U.S.A.
(Refer to FIG. 2 and 3)
No. 340174
Machine: 8010
Published: 6-98/00
System: SWEEPING
1