Table of Contents
Advertisement
Once the meter has been powered on and the values on both
readouts have stabilized, the VOC08 automatically begins
operating in real-time measurement mode. In this mode
you can:
1) Turn the display backlight on and off by briefly pressing
the BKLT button.
2) Freeze both readouts by pressing the HOLD button.
3) Change the temperature unit to/from °F and °C by briefly
pressing the UNIT button. The VOC08 will "remember" the
unit in use when the meter powers off and will resume
using that unit for ambient, DP and WB temperatures when
it is powered on again.
4) Change the values shown on the lower readout by
pressing the MODE button. The options available by
pressing the button repeatedly are (in order): Ambient
temperature alternating with RH; Dew Point (DP)
temperature; or Wet Bulb (WB) temperature.
Using the MODE button
to change the value(s)
shown on the lower
readout
5) Adjust the high VOC concentration audible alarm
threshold. To enter threshold adjustment mode, press and
hold the SET button. This will produce a display showing
35.00 ppm (the default alarm threshold) on the upper
readout, with the "5" flashing. Using the MODE and
MAX/MIN buttons to shift the flashing digit to the left and
right, respectively, press the HOLD and BKLT buttons as
many times as necessary to increment and decrement the
value of each digit until the desired concentration threshold
8
Ambient temp
alternating
with RH
WB temp
DP temp
Advertisement
Table of Contents
