ceylan DEVRAN User Manual page 23

9. Cleaning the head part
Blocking pin
Do not clean the entire device in water or in a dishwasher!
- Caution! Make sure that there is no entry of liquids into the
10. Adjust and clean of the thickness regulator
Regulator
screw
1- At least after a daily use, the device have to be cleaned.
2- During the cleaning process, keep the device off!
3- Pull away the cutting handle part device from the mains
device.
4- Open the cover by unscrewing the bolt.
5- Place the blocking pin in the whole of the blade.
6- Turn the bolt with a screwdriver. Now you can remove
the blade carefully and start the cleaning.
Never remove the head part!!!
Do not remove the head part in the handle part!
Otherwise, you will have problems in assembly.
engine part. Do not remove the protective part!
(Use of device without the protective part is forbidden.)
It is forbidden to grease the head part!!!
You can adjust the cutting size with the regulator
screw. (see picture) During cleaning, the thickness
regulator should be removed from the device.
Cleaning the thickness regulator:
1- First turn off the device
2- Remove the cover and blade carefully
3- Adjust the setting screw at the highet position
4- Unscrew the lateral fi xing screws of the
5- Take off the thickness regulator backward
Caution!
After the cleaning there should be no
remainders of detergents.
thickness regulator
For the cleaning washing detergents are allowed
to use.
23