Troubleshooting - Samsung POWERbot VR2AR72 Series User Manual

Troubleshooting

Symptom
The POWERbot is not working at all.
The POWERbot has stopped during
cleaning.
Suction power is weak.
The POWERbot cannot find the
docking station.
The POWERbot suddenly cleans
diagonally.
POWERbot does not detect the
boundary marker and crosses the
boundary.
1_VR7200_EN_DJ68-00827B-00_AA.indd 31
fCheck if the emergency switch is on.
fCheck if all the icons are displayed on the display panel.
fCheck if the POWERbot's battery is depleted.
– When "Lo" is displayed, place the POWERbot on the
docking station to charge it.
fReplace the batteries (AAA type) if the remote controller is
not working.
fWhen "Lo" is displayed on the display panel, place the
POWERbot on the docking station to charge it.
fWhen POWERbot is immobilized by an obstacle such as a
cord, threshold etc, pick it up and move it away from the
obstacle.
– If any fabric or string is caught in a drive wheel, turn off
the emergency switch and remove the fabric or string
before using it again.
fWhen there's too much dust in the dustbin, suction power
may get weakened. Turn off the emergency switch and
empty the dustbin.
fIf the brush is blocked by foreign matter, turn off the
emergency switch and remove foreign matter from the
brush.
fWhen noise suddenly increase, turn off the emergency
switch and empty the dustbin.
fCheck if there's a power failure or whether the power plug
is unplugged.
fRemove any obstacles around the docking station that may
prevent POWERbot from returning to the docking station.
fWhen there's foreign matter on the charging pins, charging
can be affected. Clean the foreign matter off the pins.
fCheck if the docking station is installed along the grain of
wooden floors or tiles.
fThe POWERbot may clean in a diagonal direction if it is
moving to another area using the shortest route. It may also
move at a diagonal if it made contact with an obstacles at
that angle, if it was charged at the docking station at an
angle, or if the grain of the wooden/tile floor skewed is in
that direction.
fMake sure the boundary markers are attached as (
shape at 15 cm before the locations where the POWERbot
shouldn't cross.
ENGLISH-31
Checklist
)
2019-03-19 오후 5:25:54