Table of Contents
Advertisement
BI-0316
3.3.3
Mixing Buses Having Different Widths
When buses of dissimilar width are adapted to one another, the DATA BUS signals from the wider of the
two buses that end at the adapter should be terminated at the adapter.
When the adapter is the BI-0318, termination is provided by the termination resistors on this board. Be
sure to enable the appropriate (Single-Ended or Differential) set of terminators. See also the section
"SCSI-3 Mixed With SCSI-2 Option" on page 2-4.
When a SCSI-3 cable is connected to the front of the BI-0316 which has to be connected to a 8-bit
device, the following products are available to provide proper termination.
Termination Products for SCSI-3 to SCSI-2 FeedThru
Table 3-1
Product
Description
0-0869680-1
AMP SCSI terminator, High Density AMPLIMITE .050 Series Shielded
FeedThru Terminator, 68-position female to 50-position male, Single-
Ended
0-0869678-1
AMP SCSI terminator, High Density AMPLIMITE .050 Series Shielded
FeedThru Terminator, 68-position female to 50-position male, Differen-
tial
3.4
Spindle Sync Option
When two drives of the same manufacturer and type are used then the spindle synchronization option
can be activated.
Technical Manual
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Spindle Sync Option PCB Version 1.0
Figure 3-5
Page 3-3
Installation Procedures
Manufacturer
AMP
AMP
Brand Innovators
Advertisement
Table of Contents
