Table of Contents
Advertisement
Chapter 3
3.1
Introduction
This chapter provides the preparation and installation instructions for the BI-0316 module.
3.2
SCSI Bus ID Selection
A SCSI bus supports 8, 16 or 32 devices depending on the cable width used. Each device must have
an unique SCSI ID assigned. The SCSI IDs of the devices fitted can be selected using the switches
available on the BI-0316.
The device ID selection for each drive is accomplished using a hex rotary DIP switch. The SCSI ID of
drive 1 in position 1 is set with switch SW1, the SCSI ID of drive 2 is set with SW2. For 8-bit devices IDs
0 to 7 are used, for 16-bit devices IDs 0 to F are valid.
Technical Manual
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Installation Procedures
ID Selection PCB Version 1.0
Figure 3-1
ID Selection PCB Version 1.1
Figure 3-2
Page 3-1
Brand Innovators
Advertisement
Table of Contents
