Chapter 2 Functional Description; Introduction; Position Numbering; Figure 2-1 Position Numbering - Brand Innovations BI-0316 Technical Manual

Chapter 2
2.1

Introduction

This chapter provides an overview of the BI-0316 module. The block diagram of the module is shown in
"BI-0316 Block Diagram" on page A-1 and the schematics are shown in "Schematic Diagrams" on page
B-1.
2.2

Position Numbering

The BI-0316 holds up to two drives that are further referred to as drive 1 in position 1 and drive 2 in
position 2.
This numbering scheme is used for identification of the devices and their position on the BI-0316.
Detailed information about the drives that are mounted on the BI-0316 is available in appendices
"Drive 1 Manual" on page F-1 and "Drive 2 Manual" on page G-1.
The numbering scheme has no relation to the SCSI IDs of the drives on the SCSI bus. The numbering
scheme indicates the physical order of the drives on the SCSI bus as observed from the VMEbus P2
connector to the front connector. When using the internal termination option of the drives, enable this
option on the last drive of the SCSI cable.
Technical Manual
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Functional Description
Position Numbering
Figure 2-1
Page 2-1 Brand Innovators