Download Print this page

Installation; Cleaning And Maintenance; Charging The Battery - Black & Decker Dust Buster 90501843 Instruction Manual

3.6v vacuum cleaner
Hide thumbs


Table of Contents
Warning! Keep electrical appliances out
of reach from children or infirm persons.
Do not let them use the appliances
without supervision.
1. On/off switch
2. Dust bowl
Fig. A
3. Crevice tool
4. Brush tool


Fitting the charging base to the
wall (Fig. B1 & B2)
The charging base can be placed on a
worktop or fitted to the wall to provide a
convenient storage and charging point
for the appliance.
Fitting the accessories (Fig. A & C)
The appliance is supplied with the following
a crevice tool (3) for confined spaces
a brush tool (4) for furniture and
To fit an accessory, proceed as follows:
Take the accessories from the
Insert the appropriate accessory into
the front of the appliance.
You may refit the other accessory by
clicking it into the accessory holder.
To refit both accessories:
Push the accessories down until they
click into place.
The appliance can be charged while
placed on a worktop or hung on the
wall using the wall hook provided.
Before first use, the battery must be
Before first use, the battery must be
charged for at least 16 hours.
charged for at least 16 hours.
Do not leave the appliance connected
Leave the appliance connected to the
to the charger for more than 48
charger whenever it is not in use.
consecutive hours.

Charging the battery

Make sure that the appliance is
switched off. The battery will not be
charged with the on/off switch in the
on position.
Fit the appliance properly on the
charger aligning the arrow on the
charger with the split of the appliance.
Plug in the charger. Switch on at the
Leave the appliance to charge for at
least 16 hours.
For a better battery life, it is recommended
to fully run the battery down and recharge
it at least once a month.
While charging, the charger may become
warm. This is normal and does not
indicate a problem.
Warning! Do not charge the battery at
ambient temperatures below 4 °C or
above 40 °C.
Switching on and off (Fig. D)
To switch on, slide the on/off switch
(1) forward.
To switch off, slide the on/off switch

Cleaning and maintenance

Warning! Regularly clean the filters.
Cleaning the dust bowl and filters
(Fig. E & F)
The filters are re-usable and should be
cleaned regularly.
Remove the dust bowl (2) by turning
Empty the dust bowl.
Remove the filter assembly (5) by
twisting it counterclockwise.
Wash the filters in warm, soapy
water. The bowl can also be washed
if necessary. Do not immerse the
appliance in water.
Make sure the dust bowl and filters
are dry.
Refit the filter assembly (5) onto the
appliance twisting it clockwise until it
locks into place.
Refit the dust bowl onto the
appliance. Make sure the dust bowl
clicks into place.

Hide quick links:


Table of Contents

  Related Manuals for Black & Decker Dust Buster 90501843