Polaris 800 INDY XC 129 2019 Owner's Manual page 96

OPERATION
Operating the snowmobile with a faulty throttle safety switch can result in
serious injury or death in the event of an accident. If the throttle safety switch
does not shut off the engine during a carburetor/throttle system malfunction,
immediately push down the engine stop switch. Do not start the engine again
until the malfunction has been corrected by your dealer.
Test the throttle safety switch system daily before operation.
1. Sit on the seat.
2. Start the engine and allow it to idle.
3. Hold the throttle lever pin stationary by exerting pressure on the pivot pin in
the direction shown in the illustration.
4. Apply a slight amount of throttle. A properly functioning switch must shut
down the engine.
POLARIS ELECTRONIC REVERSE CONTROL (PERC)
Improper reverse operation, even at low speeds, may cause loss of control,
resulting in serious injury or death. Damage will occur to the chaincase or
transmission if shifting is attempted when the engine is operating above idle
• Shift to or from reverse only when the snowmobile is stopped and when
engine speed is at idle.
• Look behind the vehicle before and while backing.
• Avoid sharp turns.
• Apply throttle slowly.
Electronic reverse will activate only if the engine RPM is below 3000.
Engaging the starter when the engine is running WILL result in serious engine
damage, especially if the engine is in reverse. Never engage the starter when
94
WARNING
WARNING
speed.
CAUTION
the engine is running.