Advertisement
ELECTRICAL INSTALLATION
WARNING - Minimum clearances and IP zone requirements must be adhered to.
Do not locate the heater immediately below a fixed electrical point i.e. socket outlet.
WARNING: This heater must not be connected to the electricity supply via an external switching device (such as a timer) or a circuit that is regularly
switched on and off by the utility supplier. Failure to follow this warning could result in the heater's thermal cut-off being inadvertently reset and could create
a fire hazard. Cables/flexes that are supplied pre-fitted to the product must NOT be extended.
IMPORTANT - The wall bracket supplied with the heater must be used when wall mounting and the heater must be installed in the correct orientation (not
sideways). The fixings should be used to secure the bracket to the particular wall on which the heater will be installed. The heater should be positioned
observing the minimum clearances stated around the heater.
When wall mounting, this heater must be mounted on a vertical wall. It also must not be mounted on the ceiling.
10
1
3
2
3
2
4
1
www.dimplex.co.nz
Min.300mm
Min. 30mm
Min.
50mm
Min 50mm
5
At the end of its service life, the
product must be recycled.
Min.30mm
Advertisement
