Page 1
• Easy ‘How to use’ guides for storage heaters • Service and repairs • Where to buy our products • Literature downloads • Heating requirement calculator Visit ‐ www.dimplex.co.uk/support A division of GDC Group Ltd Registered No: 1313016 England VAT GB 287 1315 50004 Millbrook House Grange Drive Hedge End Southampton SO30 2DF EEE Producer Registration Number –...
Installation and Operating Instructions Cold Watcher - Models MPH500 and MPH1000 08/16283/5 Issue. 5 Feb. 12 IMPORTANT: THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE. Dear Customer, Please read the following information carefully before using the appliance for the first time for your own safety and to ensure correct use.
FREE STANDING/PORTABLE USE WARNING - THIS APPLIANCE MUST BE EARTHED The electrical installation must be carried out by a competent electrician, and be in strict accordance with the current I.E.E. regulations for Electrical Equipment in Buildings. The heater may be used free standing in either the upright or lay-flat position as shown.
USING THE CONTROLS Neon Indicator When your heater is plugged in and switched on at the mains, the neon indicator will glow showing that the heater is available for use, although the heating element may not be energized, depending on the setting on the thermostat knob: Thermostat The thermostat knob is calibrated with a scale marked * and 1to 5.
As a guide to the effectiveness of a single Cold Watcher in a greenhouse, it will raise the temperature of the shaded section of the greenhouse by approximately 8 to 9°...
Need help?
Do you have a question about the Cold Watcher and is the answer not in the manual?
Questions and answers