Siemens REMBOX2-MP Installation Instructions

Installation Instructions
Model REMBOX2-MP/REMBOX4-MP
REMBOX Mounting Plate
INTRODUCTION
INSTALLATION
COMPATIBILITY
SPECIFICATIONS
P/N 315-034211-2
The REMBOX2-MP and REMBOX4-MP Mounting Plates are used in REMBOX2 and
REMBOX4 enclosures respectively for mounting OCM-16 and SIM-16 modules. Up to
4 OCM-16 or SIM-16 modules can be mounted on a REMBOX2-MP; up to 8 OCM-16
or SIM-16 modules can be mounted on a REMBOX4-MP .
Remove all system power before installation, first battery then AC. (To power up,
connect the AC first, then the battey.)
Refer to Figure 1 on page 2.
1. Holding the REMBOX2-MP/REMBOX4-MP in your hands, place the four ¼"
holes on the REMBOX2-MP/REMBOX4-MP Mounting Plate over the four
threaded studs in the bottom of the enclosure.
2. Secure in place with the #8-32 nuts supplied.
3. Place the mounting holes in the OCM-16 and/or SIM-16 modules over the
mounting holes on the REMBOX-MP .
4. Secure the OCM-16 and/orSIM-16 modules to the REMBOX-MP using the
screws provided.
The REMBOX2-MP can only be used in a REMBOX2 enclosure.
The REMBOX4-MP can only be used in a REMBOX4 enclosure.
REMBOX2 Mounting Plate: 11.25"W x 9"H
REMBOX4 Mounting Plate: 20.875"W x 9"H
Siemens Industry, Inc.
Building Technologies Division