Test Above 1 Mb; Wait For F1 On Error; Ignore Keyboard Error; Pointing Device (Mouse) - Seco SECO104-CX700M User Manual

Pc/104-plus cpu with via eden ultra low voltage technology
Table of Contents

Advertisement

SECO104-CX700M
User Manual - Rev. First Edition: 1.0 - Last Edition: 3.1 - Author: S.B. - Reviewed by G.M.

4.3.7 Test Above 1 MB

If "Enabled" it performs the memory test above 1MByte.

4.3.8 Wait for F1 on error

If "Enabled", in case of error during the boot phase, the system halts with the request to press F1
to continue.

4.3.9 Ignore keyboard error

If "Enabled", in case of keyboard error during the boot phase, the system proceeds with the normal
boot sequence.

4.3.10 Pointing device (Mouse)

It enables or disables the mouse port.

4.3.11 Show Graphic Logo

This option allows enabling the visualisation of the graphic logo (a bitmap image 640x480 pixel in
16 colours) during the first steps of boot-up sequence. This image can be customised.

4.3.12 Internal video boot on

This option allows choosing which is the default video output at system boot. Possible choices are:
CRT only;
LCD only;
CRT + LCD;
Disabled

4.3.13 External PCI video master

This option allows disabling external PCI controller, therefore using internal video section.
4.3.14 W.D.T time-out at boot
This option allows setting the Watchdog time-out to reset the system, and it can vary between 1
minute, 3 minutes and Infinite.
4.3.15 No zero extended RAM
Enabling or disabling this option it is possible to speed up the boot sequence. When this option is
enabled, the system does not perform the extended RAM erasing (i.e., the amount of RAM not
dedicated to system), that is normally executed during RAM test at boot up.
4.3.16 Seek Hard Drive at Boot
When enabled, this option let Hard Drive's heads return to origin point during initialisation phase
4.3.17 Sec. to wait for HD reset
This option is very useful for the use of older hard disk drives, which requires more time after the
start-up before that they can grant the access. With this option it is possible to specify how much
time must the system wait before to attempt an access to the Hard Disk, in order to allow its
complete reset (possible choices are 0, 2, 4 or 8 seconds).
Copyright © 2011 SECO s.r.l.
SECO104-CX700M
pag. 33

Advertisement

Table of Contents
loading

Table of Contents