Advertisement
•
With the bed end on the floor, take either the head or foot frame and offer the two locating
brackets on the bed-end into the frame as shown in the following sequence of images.
•
Secure the bed frame to the bed end with the handknobs. Ensure the thread of the handknobs
locates in the notch on the locating bracket on the bed-end frame. Fully tighten the handknobs.
•
There should be no slack or play in these connections. Repeat this process for the other
bed-end and frame.
•
Take the 2 main bed connecting brackets shown below and insert them into the holes at the
end of one of the bed frames.
•
Use 2 of the grub screws (marked 'A') to secure them in place. Ensure the thread of the grub
screw locates in the cut-out of the connecting brackets.
•
Fully tighten the grub screw with the 4mm allen key.
•
With the frames still upright, fit the motors using the M10 socket head bolts (you will need an
8mm allen key and adjustable wrench).
•
The short motor should be fitted to the foot end frame.
•
When fitting the motors, ensure the shaft end faces towards the wooden bed end and the cable
is directed out towards you (when in normal operation facing towards the floor).
NOTE: Do not fully tighten the nuts when fitting the motors. Allow 2-3 full threads to show
through the nyloc nut. If there is nut if fully tightened there will be no free rotation of the
pivot which could result in frame damage.
Assembly and Operation
04
Advertisement
