Advertisement
Assembly and Operation
•
Remove the banding from the box and open both ends of the box.
•
Ensure the brakes on the castors are unlocked allowing the bed to be easily wheeled out of
the box.
•
Ensure the box containing the actuator seat is present.
•
Move the contents of the box and side rails to the area in
which the bed is to be used.
•
Remove the polythene packaging and carefully cut the tie
wraps holding the head and foot frames together.
•
Using a 4mm Allen Key, fully undo the grub screws marked
'A' on each sides of the frames - keep these for later use.
•
Carefully lift the frame up to clear the transportation bracket
and manoeuvre it through the bed end and place to the side.
•
Repeat this for both frames.
Note: Care should be taken when removing the beds frames from the transport bracket
as they weigh up to 19kg. Also, keep fingers / arms away from the scissor mechanisms to
avoid any possible entrapment / crushing whilst lifting the frames.
•
Remove the protective cardboard packing from the bed-ends.
•
Apply the castor brakes to one of the bed-ends.
•
Using a 6mm allen key, fully undo the allen bolt 'B' from the un-braked bed-end. The bed-end
should come away from the transportation bracket. Carefully lay the bed-end on the floor with
the frame brackets pointing upwards.
•
Remove the transportation bracket from the other bed-end and lay on the floor as with the first
bed-end.
Open the sealed box which was packed underneath the bed. This should contain:
•
8 x Handknobs
•
2 x Main bed brackets
•
1 x Short actuator and fitting bolts (foot end)
•
1 x Long actuator and fitting bolts (head end)
•
1 x Control box
•
1 x Hand remote
•
1 x Transformer
•
4 x Side rail slides
•
1 x Hand grip and strap for grab bar
03
Advertisement
