Advertisement
Quick Links
Advertisement
Summary of Contents for Abilize JUVO
- Page 1 JUVO Instruction Booklet H o m e Ca r e Be d Code: BD02011...
-
Page 2: Table Of Contents
Intended Use: Your Juvo Home Care Bed is intended for use as a replacement for household beds. They are intended to help give independence to users who are dependent on assistance from carers, aid in pressure relief (using a suitable mattress) and for making the transfer and care of the user easier for carers. -
Page 3: Technical Specification
Technical Specification Beech effect wooden bed ends Drop down side rails for easy transferring Hand control with security key Locking castors throughout Technical Specifications Dimensions Overall Length 2135mm / 84” Overall Width 1040mm / 41” Bed End Height 875mm / 34.5” 1280mm / 50.5”... -
Page 4: Assembly And Operation
Assembly and Operation • Remove the banding from the box and open both ends of the box. • Ensure the brakes on the castors are unlocked allowing the bed to be easily wheeled out of the box. • Ensure the box containing the actuator seat is present. •... - Page 5 Assembly and Operation • With the bed end on the floor, take either the head or foot frame and offer the two locating brackets on the bed-end into the frame as shown in the following sequence of images. • Secure the bed frame to the bed end with the handknobs. Ensure the thread of the handknobs locates in the notch on the locating bracket on the bed-end frame.
- Page 6 Assembly and Operation • Locate the control box on the side of the foot end motor. Plug the foot end motor (green plug) into the ‘FOOT’ socket. NOTE: It is very important to locate the plug correctly to avoid damage. Notice the location of the lug on the plug and the socket to ensure correct alignment.
- Page 7 Assembly and Operation • Connect the power supply to the mains and check the operation of the motors. If there is no function, check all connections are secure and the LED light is lit on the handset. • Ensure the security key is plugged into the socket on the side of the handset. Using the handset raise the bed to its full height and switch off the power to avoid any accidental movement during the next procedure.
- Page 8 Assembly and Operation Centre Frame Fixing: Where the two halves of the beds meet in the middle, hand-knobs should be used to connect the centre parts of the bed frames. The hand-knobs must be fitted through the foot-end first then into the threaded head-end.
-
Page 9: Safety
Safety Advice Your Juvo bed has an emergency backup function which allows the bed to be lowered in the event of mains power failure. Three 9V batteries should be fitted inside the transformer. Simply open the cover on the underside of the transformer and fit the batteries. -
Page 10: Care And Maintenance
Care and Maintenance Moving an occupied bed: • It is recommended that the bed should be unoccupied before repositioning, but should the bed need to be moved whilst occupied the mattress support base should be in its lowest position. The plug must be removed from the mains supply and all cables / leads should be positioned so that they will not interfere with the castors or persons moving the bed. -
Page 11: Troubleshooting
Troubleshooting Note: DO NOT open any of the motors or control boxes – there are no user serviceable parts inside. No Movement: • Check mains power supply. • Check transformer connection and power output. • Check control box output. • Check security key is connected correctly into handset. -
Page 12: Warranty
Warranty Your Abilize product is warranted for a period of 12 months from the date of original purchase. This warranty is not transferable. Should a defect or operating fault arise within this period the Dealer from where the product was originally purchased should be notified immediately. Failure to register the fault may invalidate the warranty.