Programming; Programming The Eib/Knx Module - iDM EIB/KNX Technical Documentation Installation Instruction

4. Programming

4. Programming
4 . 1. Pr o g r a m mi n g t h e E I B /KN X
Before starting to use the EIB-KNX module for the
fi rst time it must be programmed via the EIB/KNX bus.
The module is programmed via the ETS software
like all EIB/KNX devices. An ETS project with a pre-
confi gured module is available for programming the
EIB/KNX module
The ETS project can be downloaded
from our website at
energie.at/. (in the partner area under
accessories)
After importing the ETS project the module can be
copied into any ETS project.
8
4 . 2. EIB/ K NX Ob j e ktb e le g ung
The detailed assignment of the objects can be infer-
red from the following table.
http://www.idm-
Technical manaul EIB/KNX
The confi guration of the objects and
the module's serial interface should
not be changed! If this is not observed,
fl awless operation cannot be guaran-
teed!
It is essential to ensure that the para-
meter values marked with an * in the
following table are not altered more
than is absolutely necessary. These
values are written directly into the
EEPROM memory of the Navigator. A
permanent alteration of these values
can result in damage to the memory.
(C) IDM ENERGIESYSTEME GMBH
D I E E N E R G I E F A M I L I E