Taga Harmony TVS Series Instruction Manual page 6

2-source speaker selectors with volume control

Setting the number of speakers

Pairs

of 4Ω

speakers

Pairs

of 4Ω

speakers

If necessary remove each jumper shunt and place it in the required position (X1, X2

etc.). The positions for both channels of the specific zone should be the same.

After all settings are finished install the cover and screw in the screws. The

Speaker Selector is ready to be connected to speakers and audio sources

Additional important information:

- Only speakers of the same impedance can be used for each channel of a single

zone (for example 4,6,8Ω speakers cannot be mixed in the left channel of Zone 1).

- Impedance and number of speakers in the left channel of the zone can be

different than in the right channel of the same zone (for example 3 pieces of 8Ω

speakers can be connected to the left channel of Zone 1, and 2 pieces of 4Ω

speakers to the right channel of the same zone etc.). Maximum is 16 pieces for

both channels of the zone.

- Audio sources rated for 4/6Ω loads used with 8Ω speakers can lead to a loss of

power. We recommend using audio sources rated for 8Ω loads.

- The more speakers connected to a zone the more likely is a loss of power.

Impedance matching for 8Ω rated amplifiers

Impedance matching for 4Ω rated amplifiers

Pairs of 8Ω speakers

Table of Contents