Table of Contents
Advertisement
6.4 ERROR TABLE
MESS
DISPLAY
No event
E00
Generic fault (in
E01
memory)
Temporary internal
E02
Definitive internal
E03
Communication
E04
Over voltage error
E05
Temporary under
E06
voltage error
Definitive under
E07
voltage error
DESCRIPTION
The error log appears when no
errors have been signalled
This condition signals a system
breakdown or an internal error.
The condition for internal error is
due to a problem on the power
module. During the faulty phase
the module doesn't work. This
error
alarm condition switches off the
J3 connection on the power
module for an eventual external
signal (alarm lamp, siren, etc.)
A definitive error can be defined
as such if a temporary error
error
persists
This error condition occurs when
the
communicate with the power part.
This alarm condition closes the J3
error
contact on the power board for
possible external signals (alarm
light, siren, etc.).
This
current absorbed by the module is
greater than triple the nominal
current.
This condition can be caused
when the pump is blocked by
foreign bodies.
This alarm condition closes the J3
contact on the power board for
possible external signals (alarm
light, siren, etc.)
This error condition occurs when
the voltage is 20% less than the
nominal voltage (400V).
This alarm condition closes the J3
contact on the power board for
possible external signals (alarm
light, siren, etc.).
This
temporary under voltage condition
remains.
control
board
cannot
error
occurs
when
error
occurs
when
22 -GB-
ACTION
-
Press the START/STOP button to
attempt to exit this condition. In
case of a persistent error, contact
technical support
In the error condition it is possible
to re-establish normal functions
after
a
few
procedure
automatically for a few times.
Press the START/STOP button to
try
to
manually
condition. In case of a persistent
error,
contact
support service.
Press the START/STOP button to
try
to
manually
condition. In case of a persistent
error,
contact
support service.
Cut the power off and wait until
the LINE Led switches off and
after which turn power back on. If
the error condition occurs again,
contact your nearest assistance
centre.
the
Cut off the power supply and wait
for the LINE Led to switch off.
Check the pump freely rotates
and if necessary remove foreign
bodies
that
functioning.
Turn power back on.
If the error persists, contact your
nearest assistance centre.
Press the button START/STOP or
cut the power off and wait until the
LINE Led switches off and after
which restart the system.
If the error occurs again, contact
your nearest assistance centre
the
minutes.
This
is
repeated
resolve
this
the
technical
resolve
this
the
technical
block
correct
53
Advertisement
Table of Contents
