No Access Under Mounting Location - Humminbird AS GR50 Installation Manual

C. No Access Under Mounting Location
Use the following instructions to deck mount the Sensor and route the cable to the side
if there is not space for a cable underneath the mounting location.
NOTE: It is important to review the mounting considerations and test run
the cable route as indicated in Section 1 before proceeding with the
installation.
1. Secure the NMEA pigtail with electrical tape.
NOTE: Unless it is needed, leave the NMEA
pigtail secured to the cable. If you are
connecting the pigtail to a NMEA 0183
device, see Section 3: Connect to the
Control Head for connection information.
2. Route the cable from the Sensor to the Control
head.
• The Sensor has two wire routing notches.
Use the cable notch closest to the
intended cable route.
• If holes are required to route the cable,
they must be 3/4" (19mm) to allow for the
cable connector.
• To use extension cables, see the details
in Section 1: Choose the Mounting
Location.
15
Taping the NMEA
Pigtail to the Cable
NMEA pigtail cable out
Installation - NO Access Under
NMEA
pigtail
cable
taped