Table of Contents
Advertisement
USE AND MAINTENANCE MANUAL - ELECTRICAL EQUIPMENT
Prevent particularly violent knocks during transport by paying attention to the overall dimensions of
the goods and fastening the load so as to prevent it from tipping over.
The following precautions must always be complied with when transporting and handling the goods:
do not stand beneath suspended loads and keep at a safe distance from the area in which the load is handled;
if the load must be guided while being raised, do not use your hands or feet. Suitable equipment must be used
that allow the personnel to maintain a safe distance from the load being lifted.
2
.
2
S
T
O
R
A
G
E
2
.
2
S
T
O
R
A
G
E
If the electrical equipment supplied and/or the components shall not be used for quite a while before being installed
or shall not be used for a long period of time, this must be stored according to the precautions pertaining to the
storage place and duration as indicated below:
store in a covered and dry place, protected against the elements, where the temperature ranges from -25 °C to
+55 °C and the humidity does not exceed 50% (relative to a maximum temperature of +50 °C);
the equipment must be particularly protected against humidity and significant changes in temperature;
protect the equipment from impact and stress;
prevent the equipment from coming in contact with corrosive or anyhow aggressive substances;
set the equipment in a stable and secure position, away from heat sources, open flames and the storage of
flammable or explosive substances.
NOTE
The packaging and compliance with storage conditions are to be checked at regular intervals that do not
exceed 2 months.
2
2
.
.
3
3
U
U
N
N
P
P
A
A
C
C
K
K
I
I
N
N
G
G
The steps below must be followed before unpacking the equipment:
check the equipment supplied and ensure that it has not been damaged;
check that the supply is complete, verifying also that the technical documentation is present;
any damage must be reported immediately to the carrier, with a note countersigned by the driver;
immediately inform the manufacturer if the delivery is incomplete or parts are missing.
2
2
.
.
4
4
I
I
N
N
S
S
T
T
A
A
L
L
L
L
A
A
T
T
I
I
O
O
GENERAL INFORMATION
The Customer is responsible for the installation of the equipment's electrical connection to the supply line. The
power supply cables are to be inserted from the lower side.
The equipment must be used in a well-lit environment so as to facilitate the operator's normal routine operations and
the environmental conditions must be compatible with the technical specifications of the equipment indicated in
Chapter 1. TECHNICAL DATA.
The equipment is not suitable for function in environments with danger of explosions following
Ed. 2010/09 - Rev. 00 - Cod. M08527
N
N
the presence of gases, vapours, fogs or dusts!
ATTENTION
7/24
Hide quick links:
Advertisement
Table of Contents
