Safety Devices - VARISCO JE Series Instructions For The Use And Maintenance

USE AND MAINTENANCE MANUAL - ELECTRICAL EQUIPMENT
ATTENTION
The eventual power supply socket-plug connection of the equipment must not be used to disconnect
electrical power supply and must therefore not be disconnected when in charge: use, for this purpose,
always and only the main control panel disconnector switch.
COMPONENT
REF.
CONTROL PANEL: DESCRIPTION OF THE CONTROL ACTUATORS
1 SWITCH DISCONNECTOR
2 EMERGENCY PUSH
BUTTON
3 EMERGENCY BUTTON
INDICATOR LIGHT
4 SELECTOR STARTER
MOTOR
The operator must be aware of the action given by each actuator after having read this
Varisco SpA declines all responsibility for any damage caused to persons, equipment,
system or production, if the control actuators are activated by personnel who has not
3 . 2 S A F E T Y D E V
3 . 2 S A F E T Y D E V
Activation:
Release:
Ed. 2010/09 - Rev. 00 - Cod. M08527
FUNCTIONAL
CATEGORY
IV
III
VI
IV
Do not activate the controls by accident!
been adequately educated or informed!
I C E S
I C E S
EMERGENCY STOP BUTTON
Press the EMERGENCY STOP push button
The emergency control component is blocked.
Once the push button is activated the centrifugal pump motor stops.
Turn the push button in a clockwise direction or pull out the push button.
MAIN DISCONNECT SWITCH: disconnecting switch of the main
power supply line and control auxiliaries.
EMERGENCY STOP: press this button on the control panel to
immediately stop the electric motor.
The machine must be inspected after an emergency
stop and before resetting it so as to detect the cause that
made necessary the stop command. The cause must be
resolved before resetting the emergency. If maintenance
must be performed, the machine must be disconnected from
the sources of energy!
POWER ON: line voltage indicator on terminals of the emergency
button. The indicator goes on if the main switch is in the "I"
position and if the emergency stop function is intact.
START/STOP DEVICE. Two position selector: "0" "1".
If the selector switch is set in "0" position, it stops the motor.
If the selector switch is set in "1" position, it starts the motor.
ATTENTION!
operation manual!
ATTENTION!
EFFECTS
11/24