Throttle "Neutral Position - Windsor TRACER FS Operating Instructions Manual

THROTTLE "NEUTRAL POSITION"

ADJUSTMENT (Refer to the Console Group in
the Parts section)
The throttle is automatically returned to its neutral
position by a spring centering system. If the
machine tends to creep forward or reverse when the
operators foot is removed from the directional foot
pedal, the throttle "neutral position" may require
adjustment as described below:
1. Turn off machine and set parking brake.
2. Raise the rear cover.
3. Disconnect the batteries from the machine.
4. Remove the drive motor dust cover.
5. Locate the throttle and spring centering
assembly.
6. Disconnect the linkage rod from the throttle arm.
7. With the throttle arm free, the throttle will return
to its neutral position using its internal centering
spring.
8. Position the linkage rod balljoint over the hole in
the throttle arm. The balljoint should slide into
the hole without repositioning the throttle arm.
9. If required, shorten or lengthen the linkage rod
until proper engagement occurs.
10. Reattach linkage rod to the throttle arm.
11. Install the drive motor dust cover.
12. Connect batteries.
13. Lower hopper.
QTFSB 98351 04/25/03
MAINTENANCE
4-6