Page 3
Important information Installation Waste and Overflow installation Cleaning and Care Architec_US_.14.11.18...
Page 4
Regarding the mounting instructions Products are in compliance with following codes: Uniform Plumbing Code These mounting instructions comes as part of the Duravit National Plumbing Code of Canada bathtub and should be read carefully prior to installation. International Plumbing Code...
Page 6
Inspect tub for any potential damage that Place cardboard or blanket on the floor and Connect tub waste and overflow. may have occured during transport. turn tub over. DANGER! Fatal injury by electric shock. Make sure Affix 6 flange clips to the wall frame for side Set tub into designated frame area and that there are no electrical wires or heating support of the tub.
Page 7
Once tub is set, finish wall and tile and apply silicone as needed. Architec_US_.14.11.18...
Page 8
Waste & Overflow Installation 2-1/2" (62.75) Measure vertical distance of overflow to Measure horizontal distance of drain center Attach rubber gasket and install the drain and cut pipe length. to overflow and cut drain pipe to match overflow against interior of wall. length.
Page 9
90° “Click” « Clic » “Clic” Once set, turn sleeve 90 degrees to secure Connect drain and overflow using gasket and Using provided gaskets, attach the drain to adaptor. push button to overflow and then remove the tub and insert get screw to drain. yellow sleeve.
Page 10
Care Kits can be purchased online through one of the certified parts distributors listed on our website: http://www.duravit.us/website/homepage/service/parts.us-en.html http://www.duravit.us/website/homepage/service/find_a_retailer.com-en.html (If you cannot access the above link, go to www.duravit.us and click on the Service tab at the top. Then click Find a Retailer in the left column.) Architec_US_.14.11.18...
Need help?
Do you have a question about the Architec 700353 and is the answer not in the manual?
Questions and answers