Philips 37PFL8694H/12 User Manual page 55

This section describes commonly encountered
issues and accompanying solutions.
Disconnect the power cable from the
power outlet. Wait for one minute then
reconnect it.
Check that the power cable is securely
connected.
When the TV is switched on, the front LED
indicator fl ashes for about 20 to 25 seconds.
This is normal behaviour. During this time, the
TV will not respond to the remote control
or side controls. When a picture appears on-
screen, the TV responds only to the following
remote control buttons for the fi rst few
seconds:
(
( ) and
be used when the front LED indicator stops
fl ashing.
Check that the remote control batteries
are correctly inserted according to the
+/- orientation.
Replace the remote control batteries if
they are fl at or weak.
Clean the remote control and TV sensor
lens.
Disconnect the power cable from the
power outlet. Wait until the TV cools
down before reconnecting the power
cable. If the blinking reoccurs, contact
Philips Consumer Care.
54
), (
. All buttons can
Enter '8888'.
Change the TV menu to your preferred
language (see 'Change language settings'
on page 13 ).
No action is required. The creaking sound
is normal expansion and contraction of
the TV as it cools down and warms up.
This does not impact performance.
This is normal behavior. The startup
screen is displayed when the TV is
disconnected from the mains and
reconnected.
),
Check that the correct channel list is
selected.
Check that the TV supports DVB-T, DVB-
T Lite or DVB-C in your country. See the
listed countries on the back of the TV.