Siemens 7XV5655-0BB00 Manual page 50

English
Change passwords.
ATZ
ATZ=master password Changes the master password (default empty)
ATZ1..9=User password Assign user password.
ATZ1? Queries the set password for checking
ATZ=<Enter>
ATZ1..9=<Enter>
Entries are only possible in password configuration mode (see ATP).
Up to 9 passwords may be saved in the modem.
Passwords consist of up to 8 characters, no distinction is made between upper and lower
case letters. Special characters are allowed.
If the master password has been forgotten, the device must be sent in.
(For address, see last page of this manual)
Outputs the firmware version.
AT%V
AT%V
Loads the default configuration.
AT&F
AT&F
This command loads the factory (default) settings. The IP address and all settings that are
only set in password configuration mode are retained.
The following registers were not reset:
Register Definition
S1 Number of rings (read only)
S31 Baud rate
S32 Parity
S33 Data bits
S34 Stop bits
S81 Password protection
S99 Time between two rings
S100 Own IP
S101 Default gateway
S103 Subnet mask
S104 MAC address
S110-119 Valid IP addresses for call accept
50 / 77
Deletes the master password.
Deletes the user password.
(is equivalent to ATI3)
7XV5655-0BB00
Note:
This command is also only
executed with the currently
set baud rate and the
appropriate data format,
i.e. the modem does not
feature automatic baud
rate detection.
C53000-G1176-C175-2