Related Manuals for PEERLESS PRS-KIT0811
Summary of Contents for PEERLESS PRS-KIT0811
- Page 1 Installation and Assembly: Model: PRS-KIT0811, PRS-KIT1420, PRS-KIT2026 This product is UL Listed. It must be installed by a qualified professional installer. Max UL Load Capacity: 25 lb (11.3 kg)
-
Page 2: Table Of Contents
Note: Read entire instruction sheet before you start installation and assembly. WARNING • Do not begin to install your Peerless product until you have read and understood the instructions and warnings contained in this Installation Sheet. If you have any questions regarding any of the instructions or warnings, please call Peerless customer service at 1-800-729-0307. -
Page 3: Parts List
Parts List Description Qty. Part # extension pipe 154-1025 154-1032 154-1034 adjuster tube 154-1028 154-1030 M5 x .8 x 10 mm phillips screw 520-9250 M10 x 60 mm carriage bolt 580-1022 M10 center lock nut 530-9402 projector mount assembly 055-0604 flat washer 540-1078 #14 x 2.5 phillips hex head wood screw... -
Page 4: Installation To Wood Joist Ceiling
Installation to Wood Joist Finished Ceilings, Exposed Wood Joists, or Wood Beam Ceilings Drill two 5/32" (4 mm) dia. holes to a minimum depth of 2.5" (64 mm). Attach ceiling plate (K) with two #14 x 2.5" (6 mm x 65 mm) wood screws (I) as shown using 3/8"... -
Page 5: Installation To Concrete Ceiling
Installation to Concrete Ceilings Drill two 1/4" (6 mm) dia. holes to a minimum depth of 2.5" (64 mm). Attach ceiling plate (K) using two concrete anchors (J) and #14 x 2.5" wood screws (I) CONCRETE CEILING as shown in Illustration A and 1, 2, and 3 (below). Tighten all fasteners. -
Page 6: Installation Of Extension Column
Installation of Extension Column Attach threaded end of adjuster tube (B) to threaded fitting in ceiling plate (K). Tighten securely aligning slot in end of adjuster tube (B) with one of the holes in the side of threaded fitting. Insert and tighten one M5 x .8 x 10 mm phillips screw (C) to lock adjuster tube (B) to threaded fitting. -
Page 7: Installing Projector Mount Assembly To The Extension Column
Installation to Extension Column Screw projector mount assembly (F) onto extension column (A). Tighten swivel stop screw against extension column using a phillips head screw driver. Note: Swivel stop screw is used to jam against threads of extension column (A) to prevent any excess movement of projector mount assembly (F). -
Page 8: Projector Alignment
IMPORTANT: For security installations, insert one #10-32 x 1/4" socket pin screw (L) through projector mount assembly (F) and into connection block as shown. CONNECTION BLOCK Projector Alignment Projector Alignment Projector Alignment Projector Alignment Projector Alignment To adjust yaw (swivel): Loosen screw on projector mount assembly (F) indicated below until projector mount can be rotated.