Hilti UD 4 Service Instructions Manual

HOW TO CHANGE
SUPPLY CORD FOR
HILTI DRILL UD 4
STEP 1
Turn the 9 screws off the body,
take out the cover.
STEP 2
Turn the two screws off to
release the cable holder.
STEP 3
Loosen the two screws which is
under the cable holder to release
the cable. Take black and white
STEP 4
Put the new cable in place. Tighten
the screw after inserting black and
white cables as before.
cables out.
STEP 5
Place the cable holder and
cable into its place carefully.
STEP 6
Screw the cable holder back
into its place.
STEP 7
Put the cover back in place, make
sure none of the cables are stuck.
STEP 8
Fix all the 9 screws back.
Connect with us