Analogue Switch Off; Input Selection - Toshiba WLT68 Owner's Manual

Defining the INPUT and OUTPUT sockets so that the television recognises connected equipment. See page 6
for a clear view of the back connection recommendations.
Most media recorders and decoders send a signal
through the SCART lead to switch the television to the
correct Input socket.
Alternatively press the external source selection button
B until the picture from connected equipment is shown.
This button must be used to view equipment connected
using the COMPONENT VIDEO INPUT (EXT3C).
An S in the display e.g. 2S (EXT 2S), indicates the
B
input is set for an S-Video signal.

Input selection

Use the Input Selection if the television does not switch
over automatically.
Press to select
B B
1
HDMI1, HDMI2, HDMI3 or PC.
HDMI™ displays equipment connected to Input
HDMI on the back of the television. It is designed
for best performance with 1080i high definition
signals.
PC displays a computer connected to Input
RGB/PC on the back of the television.
To return to television mode press and hold
2
and then select DTV or ATV.
Analogue switch-off
This is a digital television which is integrated to allow the
use of both digital and analogue services. However,
during the lifetime of this set it is very likely that
analogue services will be switched off to allow for more
new digital services.
This 'switch-off' will happen in a number of phases,
which will be advertised in your area well in advance.
It is recommended that at each phase the television is
re-tuned to ensure that existing and new digital
services can be viewed without disruption
(see the 'Auto tuning' section).
Input selection and
AV connections
3C (EXT1-3),
1, 2,
B B
B
INPUT signal selection
This specifies the type of signal going into SCART 2 (EXT2)
on the back of the television. Please refer to the
manufacturers instructions for the connected equipment.
In the SET UP menu press Q until
1
AV connection is highlighted, then press OK.
Language
Country
Auto tuning
Manual tuning
Antenna Amplifier
AV connection
Back
MENU
With S or R select either AV or S-VIDEO as the
2
required input for EXT2.
PC/HDMI1 audio
HDMI1 audio
EXT1 output
EXT2 input
EXT2 output
Woofer
MENU Back
If the colour is missing try the alternative setting.
32
SET UP
English
UK
OK
OK
On
OK
Watch TV
EXIT
AV connection
PC
Digital
DTV
AV
DTV
Internal
EXIT Watch TV
1/2