Wall Mounting - HoMedics SOUNDSPA PREMIER Instruction Manual And Warranty Information

Clock radio sound machine with time projection & temperature reading

Hide thumbs Also See for SOUNDSPA PREMIER:

Table of Contents

Available languages

Remote Sensor Battery Installation:

1. Loosen the 4 screws securing the battery cover with a small screwdriver

(included) and remove. Insert 2 alkaline AAA batteries according to the polarity

direction indicated.

2. Place the home receiver (SoundSpa Premier) as close as possible to the remote

sensor. This will help with synchronization between the two units.

NOTE: Once you are ready to position your remote sensor and home

receiver, ensure that the distance is not outside the effective transmission

range (100 feet). Some building materials and location of the home receiver

or remote sensor can affect transmission quality and range. Try various

locations for best results.

3. Press the C/F button inside the remote sensor to change between

(The remote sensor is preset on

4. Press the TX button inside of the remote sensor to verify the reception.

5. Replace the cover and tighten the 4 screws.

NOTE: It is recommended to test the units next to each other to ensure that

both the remote sensor and home receiver are properly synchronized.

Remote Sensor Mounting Instructions

The Remote Sensor comes with a table stand or can be wall mounted.

Table Stand -

Simply fold out the attached stand from the mounting bracket.

Wall Mounting -

Set a screw in the desired hanging location and mount. A screw and wall anchor

have been included for your convenience.

NOTE: Keep the remote sensor out of direct sunlight and rain.

Do not mount on metal surface.

F.)

C and

Table of Contents